MPF
Automated Backflush, High-Flow Filter
The MPF filter series helps to prevent contamination problems by effectively removing suspended solids from process water from coarse particles down to very low levels (~1 mg/litre or 1 ppm). Highly effective metallic media and automated systems provide a constant supply of cleaned water up to very high flow rates of 800 l/min (210 gpm) as well as automatic backwashing with simultaneous forward filtration. It promotes water conservation efforts in plants since it is capable of treating contaminated recycle water.
×
Recommended for You
Features
- California Residents: PROPOSITION 65 WARNING
- Filtration rating at 25 µm or 50 µm at 98% Efficiency
- Process flow rates from 250-800 l/min with up to 4 units connected in parallel (flow rate up to 3200 l/min), under one master control system
- Efficient automatic backflush with element lifetime longer than 12 months
- Control system runs, monitors and logs essential data
- Metallic wire fine-mesh filter enables removal of suspended solids in the water
Parameters
- Temperature Limits
- 0-100 °C (32-212 °F)
- Pressure Limits
- Minimum feed pressure (at filter inlet) typical 4-5 bar (58-72 psi)
Maximum operating pressure 16 bar (232 psi)
Backflush trigger differential pressure typical 2-3 bar (29-45 psi)
Maximum differential pressure 6 bar (87 psi) - Flow Rate
- 250-800 l/min
Connect up to 4 units for maximum 3200 l/min
Recommended Applications
- Water for pump seals and process water re-use
- Gland water, dust suppression and tailings water
- Protection for reverse osmosis systems
- Cleanup of incoming surface water to plants
Contact Us
Hundreds of experts. Over 200 global locations. Innovation and service to help you succeed.